My power supply is feeding the esp32-pico with 5v tho it says that there is 0 amps power drain, already there I know something isn't working since the power drain should be around 0.048amps,

when I measure the vdda pin where the power goes into the chip it reads 3.3v which is perfect, but any of the other vdda power pins reads 0v, could this be because I'm powering the EN pin from the chip and not directly from the power sources?

in other words, do the other power pins turn off with the chip?

other information:

I have a powerbumb turning the 5v into 3.3v

if EN = low: module is turned off if EN = high module is on (don't leave EN floating) https://www.espressif.com/sites/default/files/documentation/esp32-pico-d4_datasheet_en.pdf

(I know the antenna doesn't work)