1

I want to use RX(0) and TX(1) Pins to make Arduino as an RS485 slave. To do this I am using MAX485 IC (Breakout board) https://datasheets.maximintegrated.com/en/ds/MAX1487-MAX491.pdf

The problem here is that I don't have any other pins remaining to interface with the module in order to pull the DE/RE pin HIGH/LOW.

Can anyone suggest a way to do this without using one additional pin?

Improve this question
2
  • 2
    ti.com/lit/ug/tidubw6/tidubw6.pdf Commented Jan 12, 2019 at 13:47
  • @Majenko Thanks. I could definitely use the NA555. Commented Jan 12, 2019 at 13:50

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.