/*
* 115200. Connect GPIO 0 of your ESP8266 to VCC and reset the board
*/
#include <ESP8266WiFi.h>
#include <WiFiClient.h>
#include <ESP8266WebServer.h>
#include <ESP8266mDNS.h>
MDNSResponder mdns;
// Network id and pw
const char* ssid = "MY_ID";
const char* password = "MY_PASSWORD";
ESP8266WebServer server(80);
String webPage = "";
int gpio0_pin = 0;
int gpio2_pin = 2;
void setup(void)
{
webPage += "<h1>ESP8266 Web Server</h1><p>Socket #1 <a href=\"socket1On\"><button>ON</button></a> <a href=\"socket1Off\"><button>OFF</button></a> </p>";
webPage += "<p>Socket #2 <a href=\"socket2On\"><button>ON</button></a> <a href=\"socket2Off\"><button>OFF</button></a></p>";
// preparing GPIOs
pinMode(gpio0_pin, OUTPUT);
digitalWrite(gpio0_pin, LOW);
pinMode(gpio2_pin, OUTPUT);
digitalWrite(gpio2_pin, LOW);
delay(1000);
Serial.begin(115200);
WiFi.begin(ssid, password);
Serial.println("");
// Wait for connection
while (WiFi.status() != WL_CONNECTED)
{
delay(500);
Serial.print(".");
}
Serial.println("");
Serial.print("Connected to ");
Serial.println(ssid);
Serial.print("IP address: ");
Serial.println(WiFi.localIP());
if (mdns.begin("esp8266", WiFi.localIP()))
Serial.println("MDNS responder started");
server.on("/", []()
{
server.send(200, "text/html", webPage);
});
server.on("/socket1On", []()
{
server.send(200, "text/html", webPage);
digitalWrite(gpio0_pin, HIGH);
delay(1000);
});
server.on("/socket1Off", []()
{
server.send(200, "text/html", webPage);
digitalWrite(gpio0_pin, LOW);
delay(1000);
});
server.on("/socket2On", []()
{
server.send(200, "text/html", webPage);
digitalWrite(gpio2_pin, HIGH);
delay(1000);
});
server.on("/socket2Off", []()
{
server.send(200, "text/html", webPage);
digitalWrite(gpio2_pin, LOW);
delay(1000);
});
server.begin();
Serial.println("HTTP server started");
}
void loop(void)
{
server.handleClient();
}
Hi I'm trying to make a wifi webserver with the ESP8266 using an Arduino. The code is in this link: code. I'm following the steps of this site. I've connected my yp-01 (USB to serial) with my ESP8266.
- USB --> ESP
- TX --> RX
- RX --> TX
I use the 3.3V supply of my arduino mega.
- ARDUINO --> ESP
- 3.3V --> VCC
- GND --> GND.
When I try to upload the code it gives the error:
warning: espcomm_sync failed error: espcomm_open failed error: espcomm_upload_mem failed
I've read a lot of posts but none of them fixed my problem. Is there anyone who knows the solution or someone who had the same problem? I'm using ARduino IDE 1.6.9
