1

I am looking to use a beagle bone black with codesys to read signals through the CANBUS.

I am following the instructions from codesys on how to install their software on the beaglebone. The first thing is to flash the BBB with the latest debian image. For this I am using Balena etcher, which says it has completed successfully. It has taken about 4GB on the SD card and I cannot view the files as they are in a partition, is this correct?

Following the usual intrustions like :https://beagleboard.org/getting-started#:~:text=The%20access%20point%20password%20defaults,8. doesn't make the 4 LED's light up in the pattern like I've seen on videos. And therefore the image hasn't flashed?

I started to follow the instructions : Unable to Flash eMMC from SD Card BeagleBone Black however when I use the line "sudo nano boot/uEnv.txt" I get the error "Directory 'boot' does not exist".

enter image description here

Does this mean there is an issue with the image? However, I have used more than one SD card and re flashed them etc.

Any help would be great!

Improve this question
Related questions
30
Beagleboard bare metal programming
4
Beagleboard: Erased NAND flash and now not booting
2
Beagle Bone serial communication
Load 7 more related questions Show fewer related questions

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.